The TAF-101 Solar Climate Simulation Test Chamber is specifically designed for environmental reliability testing of products such as photothermal modules.

The TAE-103 PV (Photovoltaic) Power Plant Irradiance Meter is mainly used for irradiance collection of PV power plants and calculation of PV power plant PR (Performance Ratio) values.

The TAE-104 Portable Solar Cell IV Tester is mainly used for measuring the volt-ampere characteristics of outdoor solar cell arrays/modules/cells. It can conveniently and quickly test the operating characteristics of solar cell arrays/modules/cells under natural light, providing test support for the design, acceptance, and maintenance of solar power plants. It is an indispensable testing tool for power plant construction units, quality inspection departments, manufacturers, scientific research institutions, etc.

The TAE-102 Portable EL Detector enables rapid and accurate EL detection of photovoltaic modules. It achieves perfect and precise automatic focusing in low-light/dim-light/no-light environments, and its infrared refractive index of up to 99.8% provides superior detection image quality with low current and short exposure time.

The TAE-107 Inverter Efficiency Tester adopts current clamps for current sampling, enabling real-time recording and analysis of power at different nodes in a power plant while the plant is in normal operation. The entire unit is equipped with an irradiance measurement system, which can measure accurate real-time power generation efficiency at each node of the power plant and automatically calculate the PR (Performance Ratio) value within the system.

The TAE-106 Insulation and Grounding Comprehensive Tester is applied for electrical safety testing of photovoltaic (PV) power plant systems and insulation testing of high-voltage power equipment. The entire unit covers voltage and current testing, continuity grounding testing, polarity testing, Voc (Open-Circuit Voltage), Isc (Short-Circuit Current), insulation testing, insulation fault location, grounding testing, etc.

The TAE-108 Handheld Power Quality Analyzer can record and analyze all on-site power quality parameters including harmonics, voltage, current, frequency, fluctuation, flicker, power, and three-phase unbalance. It also features advanced measurement functions such as transient power monitoring, oscillography analysis, energy efficiency loss evaluation, and inverter measurement. The measurement results can be further analyzed using free upper computer analysis software, providing accurate data support for power grid power quality management.

The APS1000C series steady-state solar cell module tester is a steady-state solar simulator with LED light source, designed for the testing and light soaking requirements of perovskite solar cells. The device adopts a direct light structure to simulate real sunlight irradiation conditions, featuring top-down direct lighting. It covers a spectral range of 350-1200nm, with an adjustable pulse width of 1S to 100S or continuous operation mode. Equipped with a built-in test transmission unit, the device offers multiple operation modes including production line mode, preprocessing mode, and manual mode.

The APS-400C steady-state solar simulator adopts LED light source, designed for the testing and light soaking of perovskite solar cells. Featuring a direct light structure, the equipment simulates real sunlight irradiation conditions, covering a spectral range of 350-1200nm with an adjustable flash duration of 1S~100S or continuous operation.